14
COOLING SYSTEM
14.5
Refilling coolant
Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
–
Position the motorcycle upright.
–
Place a suitable container under the water pump cover.
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump cover
S01152-10
Main work
–
Make sure that screw
–
Position the motorcycle upright.
–
Take off radiator cap
S01152-10
–
Remove bleeder screw
–
Pour coolant in up to measurement
Guideline
10 mm (0.39 in)
Coolant
–
Mount and tighten screws bleeder screw
–
Mount the radiator cap.
S01151-10
Finishing work
–
Take a short test ride.
–
Check the cooling system for leaks.
–
Check the coolant level. (
. Take off radiator cap
with a new seal ring.
is tightened.
.
.
above the radiator fins.
1.0 l (1.1 qt.)
p. 69)
.
M6
10 Nm (7.4 lbf ft)
Coolant (
p. 87)
.
70