Table of Contents
Advertisement
10
TUNING THE CHASSIS
10.14
Handlebar position
10.15
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
Guideline
Rebound damping
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
On the upper triple clamp, there are two holes at a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
C00248-10
–
Remove screws
it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten
screws
C00249-10
Guideline
Screw, handlebar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap widths are even.
15 mm (0.59 in)
3.5 mm (0.138 in)
. Take off the handlebar clamps. Remove the handlebar and lay
. Remove the handlebar support.
.
M10
18 clicks
15 clicks
12 clicks
to each other.
from the center.
Loctite
40 Nm
(29.5 lbf ft)
and tighten evenly.
M8
20 Nm
(14.8 lbf ft)
31
®
243™
Advertisement
Table of Contents
