KTM 85 SX 19/16 2017 Owner's Manual page 64

12 BRAKE SYSTEM
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
–
Stand the vehicle upright.
–
Remove screws
–
Take off the cover with the washer and membrane
–
Press the brake piston back into the basic position and ensure that brake fluid does
not flow out of the brake fluid reservoir, sucking it away if necessary.
H01390-10
–
Take off cotter pin
–
Take off retaining spring
–
Clean the brake caliper.
H01392-10
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
H01393-01
–
Position retaining spring
–
Mount pin
Guideline
Pin, rear brake
Info
To make it easier to mount the pin, push the retainer spring down.
Make sure the retaining spring is seated correctly.
H01392-10
–
Mount cotter pins
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.

.

and remove bolt
 and remove the brake linings.

.

.

.

.

.
M6 4 Nm (3 lbf ft)
62