Selecting The Nt Link (1:N) Communications Speed - Omron NT20S-ST121B-EV3 User Manual

Setting the Conditions of Communications with the Host by Using the Memory Switches
3-5-4

Selecting the NT Link (1:N) Communications Speed

96
When using the NT20 with the NT Link (1:N), the baud rate of the communica-
tions with the PLC can be set. Use the "Comm. Speed" switch and select High
or Standard.
Select the speed of the communications with the PLC by the menu operation
from the System Menu as described below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting
I/O Check
Init. Memory
Memory Switch
[ MEMORY SW MENU ]
Comm. Type
Key Sound
Buzzer Sound
Bk light Off
Tool Mode
[ MEMORY SW MENU ]
Automatic Reset
Unit No.
Comm. Speed
Comm. Port
Language
To set and quit the menu, press the [WRT&EXIT] touch switch. To quit without
setting, press [Quit].
Select "Maintenance
Mode".
Select "Memory Switch".
DIP-SW Status
Select "Page".
(1/2)
Quit
If the NT Link 1:N is not
NT Link 1:N
selected, press the "Comm.
Page
OFF
Type" touch switch and
select "NT Link 1:N".
OFF
WRT
None
&
NT20
EXIT
Each time the "Comm.
(2/2)
Quit
Speed" touch switch is
No
pressed, the setting option
alternates between "High"
7 Page
and "Standard".
Standard
WRT
Port B
&
English
EXIT
Section 3-5