Selecting The Host Link Communications Speed - Omron NT20S-ST121B-EV3 User Manual

Setting the Conditions of Communications with the Host by Using the Memory Switches
3-5-3

Selecting the Host Link Communications Speed

When using the NT20 with the host link, the baud rate of the communications
with the PLC can be set. Use the "Baud Rate" switch and select 9600 bps,
19200 bps, 38400 bps, 57600 bps, or 115200 bps.
The factory setting has been made at 9600 bps.
Select the baud rate of the communications with the PLC by the menu opera-
tion from the System Menu as described below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting
I/O Check
Init. Memory
Memory Switch
[ MEMORY SW MENU ]
Comm. Type
Key Sound
Buzzer Sound
Bk light Off
Tool Mode
[ MEMORY SW MENU ]
Automatic Reset
Baud Rate
Comm. Port
Language
To set and quit the menu, press the [WRT&EXIT] touch switch. To quit without
setting, press [Quit].
Select "Maintenance Mode".
Select "Memory Switch".
DIP-SW Status
Select "Page".
(1/2)
Quit
If the host link is not select-
Host Link
ed, press the "Comm.
Page
Type" touch switch and se-
OFF
lect "Host link".
OFF
WRT
None
&
NT20S
EXIT
Each time "Baud Rate" is
(2/2)
Quit
pressed, the setting that is
No
displayed will change.
Page
9600bps
Port B
WRT
English
&
EXIT
Section 3-5
95