Support Tool Mode Setting (Nt20-St121-E) - Omron NT20S-ST121B-EV3 User Manual

Various System Settings
(NT Link (1:N))
[ MEMORY SW MENU ]
Automatic Reset
Unit No.
Comm. Speed
Comm. Port
Language
DIP-SW2-2 is OFF.
[ MEMORY SW MENU ]
Automatic Reset
Baud Rate
Comm. Port
Language
(NT Link (1:N))
[ MEMORY SW MENU ]
Automatic Reset
Unit No.
Comm. Speed
Comm. Port
Language
3-8-5

Support Tool Mode Setting (NT20-ST121-E)

(2/2)
Quit
No
Page
7
Standard
WRT
Port B
&
English
EXIT
(Host link)
(2/2)
Quit
No
Page
9600bps
Port B
WRT
English
&
EXIT
(2/2)
Quit
No
Page
7
Standard
WRT
Port B
&
English
EXIT
By setting "Tool Mode" to "NT20M", the NT20 can be used in the same way as
the conventional NT20M/NT20S, and it becomes possible to use the NT
Series Support Tool (version 2.@).
However, the following restrictions apply when "NT20M" is set:
• Version 5 of the direct connection function cannot be used.
• The PT type setting must be "NT20M".
• High-speed data transfer with the Support Tool is not possible.
• It is not possible to transfer the direct information alone.
• When screen data transmission is in screen units, simultaneous transmis-
sion of multiple screens is not possible. An attempt to transmit multiple
screens may destroy the screen data.
• When screen data transmission is in screen units, transmission with verifi-
cation set is not possible.
• The image data memory must be initialized before starting transfer in file
units.
• Screen data for RS-232C communications cannot be used.
(NT Link (1:1))
[ MEMORY SW MENU ]
Automatic Reset No
Comm. Port
Port B
Language
English
Section 3-8
(2/2)
Quit
Page
WRT
&
EXIT
111