3-11 Transferring The Resource Data - Omron NT20S-ST121B-EV3 User Manual

Transferring the Resource Data

3-11 Transferring the Resource Data

Note
Transferring the Resource
Data from the System
Transfer Tool
Reference
Operation
The resource data of the NT20 can be changed using the System Transfer
Tool.
The System Transfer Tool is automatically installed in the personal computer
when the NT20 Support Tool is installed.
For details on how to start up the System Transfer Tool, and the System
Transfer Tool operation, refer to the NT-series Support Tool Operation Manual
(V061-E1-@).
An NT20 which has no resource data registered in it will display a resource
error screen.
For details on System Transfer Tool operations, refer to the NT-series Support
Tool Operation Manual (V061-E1-@).
In order to transfer the resource data from the System Transfer Tool, first con-
nect the NT20 to a personal computer running the System Transfer Tool using
the appropriate cable, then proceed as follows.
The NT20 uses the same connector (Port A) for connection to the Support
Tool and connection to the host. If this connector is currently connected to the
host, disconnect the cable from the host and connect it to the Support Tool
(personal computer) before attempting to transfer the resource data.
1. Connect the NT20 to the personal computer running the System Transfer
Tool, then turn ON the power to the NT20.
2. Turn ON the power to the personal computer and start up the System
Transfer Tool.
3. When the power to the NT20 is turned ON, the screen shown below will be
displayed.
[ Resource Transmit ]
Erase resource
Download resource
4. Press the Download resource Button to enter the resource transfer mode,
as shown below.
[ Download Resource ]
ABORT
5. The NT20 is now on standby for reception. Start transfer of the program
using the System Transfer Tool.
Section 3-11
129