Verify Keypad Parameters And Drive Parameters - YASKAWA GA80U4720ABM Manual

4.6 Keypad Operation
6.
Push or
The keypad will show the "End" message when the write process is complete.
Note:
The keypad display changes when the settings and conditions change.
A - A1-02 [Control Method Selection]
settings
B - o2-04 [Drive Model (KVA) Selection]
settings (2 or 3 digits)
C - Presence of DriveWorksEZ
parameter backup
◆

Verify Keypad Parameters and Drive Parameters

This procedure makes sure that the parameter setting values that you backed up in the keypad agree with the
parameter setting values in the drive.
Note:
• Always stop the drive before you start to verify the parameters.
• While you restore parameters, the drive will not accept Run commands.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for
2.
Push (Menu).
3.
Push or
168
to select the backed-up parameter data, then push
, push
to select [Parameter Backup/Restore], then push
.
D - Parameter backup data is not
registered
E - Backup data does not contain the
date Information
F - Backup date
(Back), and then push
.
YASKAWA SIEPC71061737B GA800 Drive Technical Reference
to show [Home].