Install The Keypad In A Control Panel Or Another Device; Operate The Keypad From A Remote Location; Connect The Keypad From A Remote Location - YASKAWA GA80U4720ABM Manual

2.6 Install the Keypad in a Control Panel or Another Device

2.6

Install the Keypad in a Control Panel or Another Device

◆

Operate the Keypad from a Remote Location

You can remove the keypad from the drive and connect it to a remote control extension cable 3 m (9.8 ft) long to
make operation easier when you cannot access the drive. You can operate a drive that is in a control panel without
opening or closing the control panel door. To order optional accessories, contact Yaskawa or your nearest sales
representative.
Name
1 m: WV001
Extension Cable
3 m: WV003
Installation Support Set A 900-192-933-001
Installation Support Set B 900-192-933-002
◆

Connect the Keypad from a Remote Location

Use the information in Table 2.1
Installation Method
Outside of the control panel
Inside of the control panel
Note:
Installation support sets are sold separately. If there are weld studs inside the control panel, use installation support set B. Contact Yaskawa
or your nearest sales representative to make an order.
NOTICE: Do not let unwanted objects, for example metal shavings or wire clippings, fall into the drive during drive installation. Put a
temporary cover over the drive during installation. Remove the temporary cover before start-up. Unwanted objects inside of the
drive can cause damage to the drive.
■
External Dimensions of Keypad
40
Model
To connect the keypad and drive.
This option is an RJ-45, 8-pin straight-through UTP CAT5e cable.
To attach the keypad to the control panel. This option uses screws.
To attach the keypad to the control panel. This option uses nut clamps.
Use this option when weld studs are located in the control panel.
to install the keypad in the best location for your application.
Table 2.1 Keypad Installation Method
Features
Simplified installation is possible. Separate installation
support sets are not necessary.
Keypad does not extend farther than the front of the control
panel.
Figure 2.10 Exterior and Mounting Dimensions
Intended Use
Necessary Tools and Installation Support Sets
Phillips screwdriver #2 (M3)
• Phillips screwdriver #2 (M3, M4)
• Installation support set A (for mounting with screws,
model: 900-192-933-001)
• Phillips screwdriver #2 (M3)
• Wrench (M4)
• Installation support set B (for mounting with nut clamp,
model: 900-192-933-002)
YASKAWA SIEPC71061737B GA800 Drive Technical Reference