Unpacking; Setting Up - Motorola LEX L10i User Manual

Item
Front Camera
Earpiece
External Charging Contacts
Battery Cover Removal Slot
microUSB Port
Rear Camera and Flash
Proximity Sensor
2.2

Unpacking

Carefully remove all protective material from the LEX series device and save the shipping container for
later storage and shipping.
Verify that the following were received:
• LEX device
• Battery Cover
• 2280 mAh Lithium-ion battery
• Charger
• USB Cable
• Regulatory Guide
• Quick Start Guide
Inspect the equipment for damage. If any equipment is missing or damaged, contact the Motorola
Solutions Support Center immediately.
2.3

Setting Up

The initial setup of the LEX device requires that the battery and any cards be installed.
NOTICE: The device may be delivered to you with battery, SIM card, microSD card and/or
CRYPTR cards already installed, activated, and ready for use. In this case, ignore steps 2
through 6 of the following section if they were already performed.
Send Feedback
Function
• Covert mode — In covert mode, all sounds,
and visual indications are turned off. See
Covert Mode on page
• Vibrate mode — Sets to vibrate only.
• Speaker on — Routes sound to the
speaker.
• Speaker off — Mutes the device.
Used to capture live video for video calls.
Provides audio in handset mode.
Provides power to the device from cradles.
Assists in battery cover removal to provide ac-
cess to the battery, SIM, CRYPTR, and mi-
croSD card holders.
Provides USB client and host communications.
Takes photos and video, and provides flash illu-
mination for the camera.
Used to switch off the LEX screen when you
hold the device close to your face during a call.
MN003475A01-B
Chapter 2: Getting Started
44.
33