Item
Rear Camera and Flash
2.2
Unpacking
Carefully remove all protective material from the LEX series device and save the shipping container for
later storage and shipping.
Verify that the following were received:
•
LEX L10g
•
Battery Cover
•
2280 mAh Lithium-ion battery
•
Charger
•
USB Cable
•
Regulatory Guide
•
Quick Start Guide
Inspect the equipment for damage. If any equipment is missing or damaged, contact the Motorola
Solutions Support Center immediately.
2.3
Setting Up
The initial setup of the LEX L10g requires that the battery and any cards be installed.
NOTICE: The device may be delivered to you with battery, SIM card, microSD card and/or
CRYPTR cards already installed, activated, and ready for use. In this case, ignore steps 2
through 6 of the following section if they were already performed.
Before using for the first time, perform the following:
1 Remove the screen protection film from the screen, see
page
33.
2 Install the public and/or Private SIM cards, see
35.
3 Install the microSD or CRYPTR card (optional), see
Encryption Card on page
4 Install the battery, see
5 Install the battery cover.
6 Charge the device, see
2.3.1
Removing the Screen Protective Film
The device is provided with a screen protective film that protects the device during shipping.
To enable proper operation, the screen protector must be removed before use.
Send Feedback
34.
Installing the Battery on page
Charging on page
37.
Function
Takes photos and video, and provides flash illu-
mination for the camera.
Removing the Screen Protective Film on
Installing the Public and Private SIM Cards on page
Installing a microSD or CRYPTR micro
37.
MN002858A01-A
Chapter 2: Getting Started
33