CAUTION!
•
Do not close the door before reattaching the door
check to the body. Damage may occur to the door
check.
•
Do not overtighten Torx fasteners, damage to the
vehicle's parts will occur.
•
Hinge pins can break if overtightened during door
install (Max Torque: 6.0 ft· lb/8.1 N·m).
4. Attach the cloth strap of the lower half-door to the
metal hook just inside the vehicle.
Cloth Strap Attachment
1 — Metal Hook
2 — Cloth Strap
5. Connect the wiring harness on the lower half-door to
the connection just inside the vehicle.
NOTE:
For front doors, make sure the wiring harness is
closed completely.
Front Door Wiring Harness
1 — Open Wiring Harness
2 — Closed Wiring Harness
6. Replace wiring access doors.
7. When the half-doors are shipped with the vehicle,
the lower half-doors will have plugs in the post holes
that must be removed prior to upper half-door instal-
lation. To remove these plugs, proceed as follows:
a. Locate the service hole in the center of each
plug of the lower half-door (two on each front and
rear door).
b. Place a tool (hook tool or trim stick is recom-
mended) in the service hole.
GETTING TO KNOW YOUR VEHICLE
Place Tool Into Service Hole Of Plug To Remove
c. Using the tool, slowly pull upwards from the cen-
ter of the plug to remove.
8. Making sure the window on the upper half-door is
completely zipped closed, insert the upper half-door
into the lower half-door by placing the posts into the
post holes.
Lower The Upper Half-Door Into Post Holes
33
2