Half-Doors - If Equipped - Jeep GLADIATOR 2022 Owner's Manual

32 GETTING TO KNOW YOUR VEHICLE
Lower Mirror Assembly Onto Bracket
8. Insert the three mirror screws into the mirror assem-
bly, and tighten into the mirror bracket using a
#30 Torx head driver. Recommended torque specifi-
cation for the mirror screws is 4 ft-lb (5.5 N·m).
Mirror Screw Locations
9. Repeat the steps on the other side of the vehicle.
NOTE:
If this kit is being installed with the optional lamp
bracket, the bracket bushing from step 4 is not needed.
Use the spacer from the lamp bracket.
HALF-DOORS — IF EQUIPPED
CAUTION!
•
Do not run half-doors through an automatic car
wash. This may result in scratches and wax
buildup on the windows.
•
Careless handling and storage of the half-doors
may damage the seals resulting in water leaks into
the interior of the vehicle.
•
The upper half-doors must be positioned properly
to ensure sealing. Improper installation can cause
water leaks into the interior of the vehicle.
•
Store the zipper pulls of the upper half-door win-
dows at the upper B-pillar area for both front and
rear doors to avoid damage to the windows when
not in use.
•
Do not attempt to operate the half-door zipper in
temperatures of 41°F (5°C) or below. Damage to
the window may occur.
Use this QR code to access your digital
experience.
This vehicle may be equipped with half-
doors. To install the half-doors in the
vehicle, follow the instruction sheet
packaged in the box the doors were
received in. Replacement parts may be
purchased through Mopar® Service.
Half-Door Installation
To install the front or rear half-doors, proceed as
follows:
1. Remove the full doors from the vehicle. For front
door removal, see
removal, see page 29.
2. Locate the upper and lower hinge pins on the lower
half-door, and lower them into the body hinges on
the vehicle.
NOTE:
The upper hinge pin is longer, which can be used to
assist in guiding the door into place during
installation.
Lower Half-Door Hinge Pins
3. Insert the upper and lower hinge pin screws into the
body hinges. Tighten the screws using a #T50 Torx
head driver to 3.8 ft· lb / 5.2 N·m.
Scan me
page 25. For rear door