Preparations For Jacking; Jack Location - Jeep GLADIATOR 2022 Owner's Manual

286 IN CASE OF EMERGENCY
WARNING!
•
Never start or run the engine while the vehicle is
on a jack.
•
The jack is designed to be used as a tool for
changing tires only. The jack should not be used to
lift the vehicle for service purposes. The vehicle
should be jacked on a firm level surface only. Avoid
ice or slippery areas.

PREPARATIONS FOR JACKING

1. Park on a firm, level surface. Avoid ice or slippery
areas.
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the
road to avoid being hit when operating the jack or
changing the wheel.
2. Turn on the Hazard Warning Flashers.
3. Apply the parking brake.
4. Shift the automatic transmission into PARK (P), or a
manual transmission into REVERSE.
5. Cycle the ignition to OFF.
6. Block both the front and rear of the wheel diagonally
opposite of the jacking position. For example, if the
driver's front wheel is being changed, block the pas-
senger's rear wheel.
Wheel Blocked Example
NOTE:
Passengers should not remain in the vehicle when the
vehicle is being jacked in position.

JACK LOCATION

The jack and tools are stored under the right rear seat.
Jack And Tool Location
To remove, proceed as follows:
1. Fold up the right rear seat.
2. Remove the jack and tools by turning the wing bolt
counterclockwise, remove the wing bolt and then lift
the assembly out from under the seat.
Jack And Tools
3. Release the tool bag straps from the jack and
remove tools from bag.
Jack And Tool Bag