Jeep GLADIATOR 2022 Owner's Manual page 57

CAUTION!
Failure to follow these cautions can cause damage to
the heating elements:
•
Use care when washing the inside of the rear win-
dow. Do not use abrasive window cleaners on the
interior surface of the window. Use a soft cloth and
a mild washing solution, wiping parallel to the
heating elements. Labels can be peeled off after
soaking with warm water.
•
Do not use scrapers, sharp instruments, or abra-
sive window cleaners on the interior surface of the
window.
•
Keep all objects a safe distance from the window.
Driver And Passenger Temperature Up
And Down Buttons
These buttons provide the driver and passenger with
independent temperature control.
Push the red button on the faceplate or
touchscreen or press and slide the tempera-
ture bar towards the red arrow button on the
touchscreen for warmer temperature
settings.
Push the blue button on the faceplate or
touchscreen or press and slide the tempera-
ture bar towards the blue arrow button on
the touchscreen for cooler temperature
settings.
SYNC Button
Press the SYNC button on the touchscreen
to toggle the Sync feature on/off. The SYNC
indicator illuminates when SYNC is on. SYNC
is used to synchronize the passenger tem-
perature setting with the driver temperature setting.
Changing the passenger temperature setting while in
SYNC will automatically exit this feature.
NOTE:
The SYNC button is only available on the touchscreen.
Blower Control
Blower Control regulates the amount of air
forced through the Climate Control system.
There are seven blower speeds available.
Adjusting the blower will cause automatic
mode to switch to manual operation. The speeds can
be selected using either the blower control knob on the
faceplate or the buttons on the touchscreen.
Faceplate
The blower speed increases as you turn the blower con-
trol knob clockwise from the lowest blower setting. The
blower speed decreases as you turn the blower control
knob counterclockwise.
Touchscreen
Use the small blower icon to reduce the blower setting
and the large blower icon to increase the blower set-
ting. Blower can also be selected by pressing the blower
bar area between the icons.
GETTING TO KNOW YOUR VEHICLE
Mode Control
Turn the mode control knob or press one of
the Mode buttons on the touchscreen to
adjust airflow distribution. The airflow distri-
bution mode can be adjusted so air comes
from the instrument panel outlets, floor outlets, defrost
outlets and demist outlets.
Panel Mode
Air comes from the outlets in the instrument
panel. Each of these outlets can be individu-
ally adjusted to direct the flow of air. The air
vanes of the center outlets and outboard
outlets can be moved up and down or side to side to
regulate airflow direction. There is a shut-off wheel
located below the air vanes to shut off or adjust the
amount of airflow from these outlets.
Bi-Level Mode
Air comes from the instrument panel outlets
and floor outlets. A slight amount of air is
directed through the defrost and side win-
dow demister outlets.
NOTE:
Bi-Level mode is designed under comfort conditions to
provide cooler air out of the panel outlets and warmer
air from the floor outlets.
Floor Mode
Air comes from the floor outlets. A slight
amount of air is directed through the defrost
and side window demister outlets.
55
2