Interval Rec - JVC GY-HC500E Instructions Manual

Interval Rec

In normal recording, when the recording stops, the
image and accompanying data from the start till the
end of the recording are recorded as one "clip" on
the SD card.
In this mode, recording and pause are performed
repeatedly at the specified time interval. Only the
specified number of frames is recorded.
The recording can be written to the media as a
single clip until it is stopped.
Memo :
Audio will not be recorded.
0
Until a specified amount of recordings is
0
accumulated, the file will not be written to the
media.
After the specified number of frames is recorded
0
and written to the media, recording will be
performed until the same number is
accumulated again.
If the specified amount is not reached when
0
recording is stopped, normal recording is
performed and frames are added to the ending
of the clip until the amount is reached. (Padding)
Press [REC]
(Interval Rec starts)
Recording resumes
[Rec Interval] [Rec Interval]
Pause Pause
Records number of frames specified in [Rec Frames]
Actual clips recorded to the media
Specific amount of data
.
1 Set [Rec Mode] to "Interval Rec".
Set [System] B [Record Set] B [Rec Mode]
0
to "Interval Rec".
(A P160 [ Rec Mode ] )
The display changes ("STBY" B "STBYN").
0
2 Set the number of frames to record in [Rec
Frames].
To configure the setting, go to [System] B
[Record Set] B [Rec Mode] B [Rec Frames].
(A P160 [ Rec Frames ] )
Press [REC]
(Interval Rec stops)
Recording resumes
Normal recording
Pause
(Padding data)
3 Set the time interval to start recording in
[Interval Rec].
To configure the setting, go to [System] B
[Record Set] B [Rec Mode] B [Rec Interval].
(A P160 [ Rec Interval ] )
4 Start recording.
Press the [REC] button to record only the
0
number of frames specified in [Rec Frames]
and pause.
After the specified time in [Rec Interval] has
0
passed, recording starts again to record only
the number of frames specified in [Rec
Frames] and pause.
Interval Rec continues until the recording is
0
stopped.
The display changes ("STBYN" B "RRECN"
B "STBYN" (red text) B "RRECN" B
"STBYN" (red text)).
The card slot status indicator lights up in red.
0
5 Press the [REC] button.
The card slot status indicator lights up in
0
green.
The display becomes "STBYN".
0
Caution :
Do not remove the SD card during recording
0
(RRECN, red text) or recording pause (STBYN,
yellow text).
To remove the SD card during Interval Rec,
0
press the [CANCEL] button, check that "STBYN"
(white text) is displayed and the card slot status
indicator lights up in green before you remove
the card.
When [TC/UB] B [TC Generator] is set to "Free
0
Run" or "Free Run (Ext)", the time code will be
recorded in "Rec Run".
Audio cannot be recorded. The audio level
0
meter is grayed out.
(A P167 [Audio Level Meter] )
95
Special Recording