Audio Set Item - JVC GY-HC500E Instructions Manual

Audio Set Item

Input1 Mic Ref.
For setting the reference input level when the
[INPUT1] selection switch is set to "MIC" or "MIC
+48V".
[Setting Values: -62dB, -56dB, R-50dB, -44dB,
-38dB, -32dB]
Input2 Mic Ref.
For setting the reference input level when the
[INPUT2] selection switch is set to "MIC" or "MIC
+48V".
[Setting Values: -62dB, -56dB, R-50dB, -44dB,
-38dB, -32dB]
Int. Mic Gain
For setting the sensitivity of the built-in microphone.
[Setting Values: 12 dB, 6 dB, R0dB]
AUX Gain
For setting the sensitivity of the [AUX] terminal
input.
[Setting Values: 12 dB, 6 dB, R0dB]
Ref. Level
For setting the recording reference level. (Applies
to both [CH1/CH2].)
[Setting Values: -12dB, -18dB, R-20dB]
Limiter
For setting the limiter operation.
-9dBFS:
0
Sets "-9dBFS" to the maximum recording level.
-6dBFS:
0
Sets "-6dBFS" to the maximum recording level.
Off:
0
Depending on the settings of the [CH1/CH2
AUTO/MANUAL] selection switches, the
operation may be different as described below.
The limiter does not function when
0
"MANUAL" is set.
The limiter functions at -6dBFS when "AUTO"
0
is set.
[Setting Values: -9dBFS, R-6dBFS, Off]
AGC Response
9 Attack Time
Sets the time to activate the limiter.
[Setting Values: Fast, RMiddle, Slow]
9 Decay Time
Sets the time to deactivate the limiter operation.
[Setting Values: Fast, RMiddle, Slow]
AGC Mode
For setting whether to link the limiter operation of
[CH1] and [CH2].
Select "Link" to link or "Separate" to separate.
[Setting Values: Link, RSeparate]
Memo :
Enabled only when both the [AUX] input terminal
0
and [INPUT1/INPUT2] input terminal are set to
"LINE" or "MIC", and CH1/CH2 of the [CH1/CH2
AUTO/MANUAL] switch is set to "AUTO".
XLR Manual Level
For setting whether to link manual audio
adjustment operation between [INPUT1] and
[INPUT2] terminals.
Select "Link" to link or "Separate" to separate.
When this item is set to "Link", adjust the recording
level using the [CH1] recording level adjustment
knob.
[Setting Values: Link, RSeparate]
Memo :
Enabled only when both the [INPUT1/INPUT2]
0
input terminals are set to "LINE" or "MIC", and
both [CH1]/[CH2] of the [CH1/CH2 AUTO/
MANUAL] selection switches are set to
"MANUAL".
When this item is set to "Link", [CH2] recording
0
level adjustment knob is disabled.
135
A/V Set Menu