Backup Rec - JVC GY-HC500E Instructions Manual

Caution :
To perform recording in the Dual Rec mode, it is
0
recommended that you start recording by
making use of two cards with the same capacity
and from the formatted state.
You can combine the use of the Dual Rec mode
0
with a special recording mode. While in the Dual
Rec mode, you can also set [Rec Mode] to
"Normal", "Pre Rec", "Clip Continuous", "Interval
Rec", or "Frame Rec".
(A P91 [Special Recording] )
(A P160 [ Rec Mode ] )
When both slots are inserted with recordable
0
cards, the Dual Rec (simultaneous recording)
operation can be performed. If a recordable
media is only inserted in one of the slots, you can
also start recording with one card.
In the Dual Rec mode, continuous recording by
0
switching from one slot to another cannot be
performed. Continuous recording will not be
performed if a recordable media is inserted in a
slot after recording to the other slot has started.
When recording to one slot is in progress with
0
the recorder set to the Dual Rec mode, inserting
a recordable media to the other slot does not
enable the Dual Rec operation. To perform the
Dual Rec operation, stop recording temporarily
(excluding pausing recording in the Clip
Continuous Rec mode), and start again.
When one of the cards is accidentally removed
0
while recording is in progress in the Dual Rec
mode, recording to the card in the other slot will
continue. However, repair of the accidentally
removed card by the recovery function may fail.
If an error occurs on one of the cards while
0
recording is in progress in the Dual Rec mode,
recording of the erroneous card stops, while that
of the other card continues.
Operations on clips recorded in the Dual Rec
0
mode, such as clip deletion in the Media mode
or appending of OK marks, can only be
performed on the card in the selected slot.

Backup Rec

Backup Rec mode enables backup recording to
0
the media in Slot B or the [EXT.SLOT] by starting
or stopping recording to Slot B or [EXT.SLOT]
independently of control using the [REC] button.
Start or stop the recording using [System] B
0
[Record Set] B [Slot Mode] B [Backup Rec] or
press the user button that is assigned with
"Backup Trig".
(A P160 [ Slot Mode ] )
(A P116 [User Switch Set Item] )
Starts Slot A starts
recording recording
to Slot B or
[EXT.SLOT]
Slot A
Slot B or
Clip 1
[EXT.
SLOT]
.
Memo :
During the Backup Rec mode (when [Slot
0
Mode] is set to "Backup Y" or "Backup G"),
you can control recording to the 2 slots at
different timings, and backup recording can only
be performed on this camera recorder.
(A P160 [ Slot Mode ] )
You can record without worrying about missing
0
the important scenes by setting slot B or
[EXT.SLOT] to be always recording (backup
recording) and using the [REC] button to start/
stop recording of only the required scenes in slot
A.
It is recommended to use a media with high
0
capacity in slot B.
Backup cannot be selected when [WFormat] is
0
configured to "High-Speed", "Exchange" (U
model) or "MP4" (E model).
Slot A stops Stops
recording
recording
to Slot B or
[EXT.SLOT]
Clip 2
Clip 2 Clip 3
89
Dual Rec