Table of Contents
Advertisement
1 Set [Rec Mode] to "Frame Rec".
Set [Main Menu] B [System] B [Record
0
Set] B [Rec Mode] to "Frame Rec".
(A P104 [ Rec Mode ] )
The display changes ("STBY" B "STBYM").
0
2 Set the number of frames to record in [Rec
Frames].
Set using [Main Menu] B [System] B [Record
0
Set] B [Rec Mode] B [Rec Frames].
(A P104 [ Rec Frames ] )
3 Start recording.
Press the [REC] button to record only the
0
number of frames specified in [Rec Frames]
and pause.
The display changes ("STBYM" B "RRECM"
0
B "STBYM" (yellow text)).
The card slot status indicator lights up in
0
green.
4 Repeat Frame Rec.
Press the [REC] button again to record only
0
the number of frames specified in [Rec
Frames] and pause.
The display changes ("STBYM" B "RRECM"
0
B "STBYM" (yellow text)).
Frame Rec continues until the recording is
0
stopped (step 5).
5 Press and hold the [REC] button.
The card slot status indicator lights up in
0
green.
Caution :
Do not remove the SD card during recording
0
("RRECM", red text) or recording pause
("STBYM", yellow text).
To remove the SD card during Frame Rec, press
0
the [CANCEL] button, check that "STBYM"
(white text) is displayed and the card slot status
indicator lights up in green before you remove
the card.
When [Main Menu] B [TC/UB] B [TC
0
Generator] is set to "Free Run" or "Free
Run(Ext)", the time code will be recorded in "Rec
Run".
Audio cannot be recorded. A x mark appears
0
in the audio level meter display.
(A P111 [Audio Level Meter] )
72
Special Recording
Interval Rec
In normal recording, when the recording stops, the
image and accompanying data from the start till the
end of the recording are recorded as one "clip" on
the SD card.
In this mode, recording and pause are performed
repeatedly at the specified time interval. Only the
specified number of frames is recorded.
The recording can be written to the media as a
single clip until it is stopped.
Memo :
Audio will not be recorded.
0
Until a specified amount of recordings is
0
accumulated, the file will not be written to the
media.
After the specified number of frames is recorded
0
and written to the media, recording will be
performed until the same number is
accumulated again.
If the specified amount is not reached when
0
recording is stopped, normal recording is
performed and frames are added to the ending
of the clip until the amount is reached. (Padding)
Press [REC]
(Interval Rec starts)
Recording resumes
[Rec Interval]
[Rec Interval]
Pause
Pause
Records number of frames specified in [Rec Frames]
Actual clips recorded to the media
.
Specific amount of data
1 Set [Rec Mode] to "Interval Rec".
Set [Main Menu] B [System] B [Record
0
Set] B [Rec Mode] to "Interval Rec".
(A P104 [ Rec Interval ] )
The display changes ("STBY" B "STBYN").
0
2 Set the number of frames to record in [Rec
Frames].
Set using [Main Menu] B [System] B [Record
Set] B [Rec Mode] B [Rec Frames].
(A P104 [ Rec Frames ] )
Press [REC]
(Interval Rec stops)
Recording resumes
Normal recording
Pause
(Padding data)
Advertisement
Table of Contents
