Clip Continuous Rec - JVC GY-HC500E Instructions Manual

Completed Clip
(Recorded video and audio)
Recording starts a
number of seconds
earlier based on the
[Pre Rec Time] setting
Press [REC]
(Recording starts)
.
1 Set [Rec Mode] to "Pre Rec".
(A P160 [ Rec Mode ] )
Set [System] B [Record Set] B [Rec Mode]
0
to "Pre Rec".
The display changes ("STBY" B "STBYO").
0
2 Press the [REC] button to start recording in
Pre Rec mode.
The display changes ("STBYO" B "RRECO")
0
and the card slot status indicator lights up in
red.
Press the [REC] button again to pause
0
recording. The display changes ("RRECO" B
"STBYO") and the card slot status indicator
lights up in green.
Caution :
When the interval between start and stop
0
recording is short, "STBYO" may not be
displayed immediately after recording is
complete.
"RRECO" B "STBYO" ("STBY" blinks in red) B
"STBYO" is displayed.
When the SD card becomes full during
0
recording, recording stops and "STOP" is
displayed.
In the following cases, video and audio before
0
the specified Pre Rec time may not be recorded
even if recording starts.
Immediately after power on
0
Immediately after recording stops
0
Immediately after switching from Media
0
mode to Camera mode
Immediately after setting [Rec Mode]
0
Immediately after the end of Clip Review
0
Immediately after changing file format
0
Immediately after changing video format
0
92
Special Recording
0
0
Example:
In normal recording, three clips are generated as
Recording 1, Recording 2, and Recording 3.
However, recording in this mode generates only
Press [REC]
one clip.
(Recording stops)
Press [REC]
(Recording starts)
.
1 Set "Rec Mode" to "Clip Continuous".
2 Start recording. (Recording 1)

Clip Continuous Rec

In normal recording, when the recording stops,
the image, audio, and accompanying data from
the start till the end of the recording are recorded
as one "clip" on the SD card.
This mode allows you to consolidate several
rounds of "startstop recording" into one clip.
Press [REC]
(Recording resumes)
Press [REC]
(Recording pauses) (Recording pauses)
Recording 1 Recording 2
Completed Clip
(Recorded video and audio)
Recording 1 Recording 2
(A P160 [ Rec Mode ] )
Set [System] B [Record Set] B [Rec Mode]
0
to "Clip Continuous".
The display changes ("STBY" B "STBYL").
0
Press the [REC] button to start recording in
0
Clip Continuous mode.
The display changes ("STBYL" B "RRECL")
0
and the card slot status indicator lights up in
red.
Press [REC]
(Recording resumes)
Press [REC] Press and hold [REC]
(Recording stops)
Recording 3
Recording 3