Replacing A Damaged Barrier - Superior Fireplaces DRI2000TEN Series Installation And Operation Manual

Replacing A Damaged Barrier

• If the barrier becomes damaged, the barrier shall be replaced
with the manufacturer's barrier for this appliance.
• For model DRI2032, use with barrier part number J4785.
For model DRI2027, use with barrier part number F4343.
Follow installation instructions.
Removing The Damaged Barrier (refer to Figure 30)
1. Make sure the unit is OFF and COLD.
2. Remove the Full Front Facade by lifting it up and away from the unit
to unseat the Full Front Facade hooks from the mounting slots on the
unit.
3. Place the Full Front Facade face down on a soft, non-abrasive surface
to prevent damage.
4. Remove barrier from Full Front Facade:
a. Using a 3/8" nut driver, remove and set aside the four nuts and 'Z'
brackets holding each corner of the barrier in place.
b. Remove the damaged barrier from the Full Front Facade and discard.
Installing The New Listed Barrier
1. Place new barrier onto the back of the Full Front Facade and reattach
by following removal instructions in reverse order, taking care not to
over-tighten the nuts.
2. Reinstall the Full Front Facade by seating the four hooks on the back
of the Full Front Facade into the mounting slots on the unit.
28
Figure 30
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Barrier
Full Front Facade