Table of Contents
Advertisement
Log Installation Instructions -
The logs have notches/tabs to assist proper positioning. Upper logs rest
on lower logs via notches/tabs. Proper log placement is critical to pre-
vent sooting. Place the logs in the gaps between flame peaks, so they do
not impinge the flames. Follow the log placement instructions precisely.
NOTE: Do not cover the burner ports.
NOTE: Ensure the left front log (1) and right front log (2) are correctly
installed on the burner positioning tabs.
1.
If necessary, remove the glass door (Page 26). Locate and bend up
Burner Locating Tabs (Figure 14A or 14B).
2.
Locate the log placement tabs (Figure 14A or 14B). Place embers
and other media (see Page 18).
Figure 14A - Locate the log placement tabs,
Tabs for
log #1
Tabs for
log #2
Figure 14B - Locate the log placement tabs,
3.
Align the notches in the bottom of the rear log (1) with the left rear
locating tabs (see Figures 14A/B and 15).
1
Figure 15 - Place log 1
DRI2027 and DRI2032
DRI2027
Tab for
log #5
Tabs for
log #3
DRI2032
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
4.
Position the left front log (2) on the left front log tab and the left
burner locating tab (See Figures 14A/B and 16).
2
Figure 16 - Place log 2
5.
Position the right front log (3) on the right front locating tab and right
burner locating tab (See Figures 14A/B and 17).
Landings for
log #4
Figure 17 - Place log 3
6.
Position the left cross log (4) on the landings on the left rear log (1) and
the left front log (2) (see Figures 17 and 18).
7.
Position the right cross log (5) over the right rear locating tab (see Fig-
ures 14A/B and 18).
4
Figure 18 - Place logs 4 and 5
3
5
19
Advertisement
Table of Contents
