Table of Contents
Advertisement
NOTE: If applicable, install the firebox liner before placing the stone.
Logs can be installed after the volcanic stone.
Installing the volcanic stone, and glowing embers:
1.
If necessary, remove the glass door (Page 27).
2. Spread the decorative volcanic stone in a pleasing pattern on the
firebox floor to the front and sides of the burner (Figure 10).
NOTE: Do not place volcanic stone on the burner.
3. Separate and fluff the glowing embers into pieces approximately the
size of a quarter (Figure 11).
4. Position the separated glowing embers over the small holes on the
burner surface (Figure 12). Do NOT cover the large burner slots.
NOTE: Enough glowing ember material is provided for several applica-
tions. For best glowing effect, replace the ember material annually.
Figure 10 - Installing the volcanic stone (DRI2032 Shown)
Figure 11 - Separating the glowing embers
18
Figure 12 - Installing the glowing embers (DRI2032 Shown)
4
Volcanic Stone
Figure 13 - Log Set
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
1
2
Log Number
Description
1
2
Left Front Log
3
Right Front Log
4
Left Cross Log
5
Right Cross Log
NOTE: It is important to ensure proper log placement per the
manual when installing these units. Verify pilot flame is not
obstructed. See Verifying Appliance Operation on Page 26.
5
3
Rear Log
Advertisement
Table of Contents
