Superior Fireplaces DRI2000TEN Series Installation And Operation Manual page 38

Table of Contents

Advertisement

LIGHTING LABEL - DRI2000 Series
38
IHP – FRONT
16-40152
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by
hand.
B. BEFORE OPERATING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your
building.
1. STOP! Read the safety information above on this label.
2. Read the Installation and Operation manual and instructions
provided with optional control (e.g. Remote Control), if
applicable.
3. Turn the unit-mounted burner ON/OFF switch and/or optional
control switch to "OFF."
4. Turn "OFF" all electric power to the appliance. Note: The
control may have a battery backup (remove batteries, if
installed).
5. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by hand.
6. Wait five (5) minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow "B" in
the safety information above on this label. If you don't smell
gas, go to the next step.
7. Turn on all electric power to the appliance. Note: The control
may have a battery backup (install batteries, if applicable).
8. Turn the unit-mounted burner ON/OFF switch or optional control
switch to "ON."
9. (if applicable) Set thermostat on remote control to desired
setting.
10. If the appliance will not operate, follow the instructions "To
Turn Off Gas To Appliance" and call your service technician or
gas supplier.
1. Turn the unit-mounted burner ON/OFF switch and/or
optional control switch to "OFF."
P/N 900797-01, Rev. 0, 09/2016
A barrier* designed to reduce the risk of burns from the hot viewing glass is pro-
vided with this appliance and shall be installed for the protection of children and
other at-risk individuals. *Included with required facade.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. If any portion of this appliance does not operate as the
instructions indicate, do not try to repair it, call a qualified
service technician. Do not use tools. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
OPERATING INSTRUCTIONS
Electronic Pilot
Assembly
Copreci Gas
Valve
TO TURN OFF GAS TO APPLIANCE
2. Turn "OFF" all electric power to the appliance. Note: The control
may have a battery backup (remove batteries, if installed).
3. Close the main line gas shut-off valve.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Switches
Learn (Some Models)
Black Wires
Optional: IPI/Cont. Pilot
Yellow Wires
Optional: Hi/Lo
Blue Wires
On/Off: Burner
Brown Wires

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dri2027tenDri2032ten

Table of Contents