Table of Contents
Advertisement
Open the door.
2.
13.6 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 29
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 36
¡ The drum is empty.
Open the door.
1.
→ "Opening the door", Page 38
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.7 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 37.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 18
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 37
Press
.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "Finished " .
13.9 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Pause/Reload .
1.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
Open the door.
2.
→ "Opening the door", Page 38
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
operation en
39
Advertisement
Table of Contents
