Table of Contents
Advertisement
13.5 Opening the door
Press on the edge of the door.
1.
Open the door.
2.
13.6 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 27
Requirements
The laundry is prepared and sor-
¡
ted.
→ "Laundry", Page 31
The drum is empty.
¡
Open the door.
1.
→ "Opening the door", Page 33
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.7 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 31.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 32
Press
.
▶
The drum rotates and load detec-
a
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
The display shows the programme
a
duration or the programme end
time.
After the programme has ended,
a
the display shows: "End".
13.9 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
.
1.
During the washing cycle, the ap-
pliance pauses.
Basic operation en
33
Advertisement
Table of Contents
