Adjusting The Programme Settings; Saving Programme Settings; Opening The Door; Loading Laundry - Siemens XQG100 User Manual And Installation Instructions

Table of Contents

Advertisement

If required, adjust the programme
5.
settings.
→ "Adjusting the programme set-
tings", Page 37
13.3 Adjusting the pro-
gramme settings
Requirement: A programme is set.
→ "Setting a programme", Page 36
Adjust the programme settings.
→ "Buttons", Page 25
Observe the information about op-
erating logic → Page 19.
Notes
¡ The programme settings are not
saved permanently for the pro-
gramme.
¡ The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Saving programme set-
tings
Requirements
¡ A programme is set.
→ "Setting a programme", Page 36
¡ The programme settings have
been adjusted.
→ "Adjusting the programme set-
tings", Page 37
Press
.
To call up the saved programme,
press Favourites in the pro-
gramme menu → Page 22.
13.5 Opening the door
Press on the edge of the door.
1.
Open the door.
2.
13.6 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 29
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 35
¡ The drum is empty.
Open the door.
1.
→ "Opening the door", Page 37
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
operation en
37

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wn54c8a10w

Table of Contents