Detergents And Care Products; Basic Operation; Switching On The Appliance; Setting A Programme - Siemens WNE4A2UPIN User Manual And Installation Instructions

en Basic operation

Basic operation

13 Basic operation
Basic operation
13.1 Switching on the appli-
ance
Requirement: The appliance has
been correctly installed and connec-
ted.
→ "Installation and connection",
Page 12
Turn the programme selector to a
▶
programme.
13.2 Setting a programme
Turn the programme selector and
1.
set the required programme.
→ "Programmes", Page 25
If required, adjust the programme
2.
settings.
→ "Adjusting the programme set-
tings", Page 30
13.3 Adjusting the pro-
gramme settings
Requirement: A programme is set.
→ "Setting a programme", Page 30
Adjust the programme settings.
▶
→ "Buttons", Page 23
Note: The programme settings are
not saved permanently for the pro-
gramme.
13.4 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 25
Requirements
The laundry is prepared and sor-
¡
ted.
→ "Laundry", Page 29
The drum is empty.
¡
30
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
Note: Observe the information about

detergents and care products

→ Page 29.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press ⁠ Start/Reload.
1.
The drum rotates and load detec-
a
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
The display shows the programme
a
duration or the programme end
time.
After the programme has ended,
a
the display shows: End.
If the display shows
2.
dry is not spun. The water is
pumped out after the rinse cycle.
, the laun-