Adding Detergent And Care Product; Starting The Programme; Adding Laundry; Cancelling The Washing Programme - Siemens XQG100 User Manual And Installation Instructions

Table of Contents

Advertisement

en operation
13.7 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 36.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 18
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 36
Press
⁠ .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "Finished" .
13.9 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Pause/Reload .
1.
During the washing cycle, the ap-
pliance pauses.
38
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
Open the door.
2.
→ "Opening the door", Page 37
Add or remove laundry.
3.
Close the door.
4.
Press
⁠ .
5.
13.10 Cancelling the washing
programme
Press Cancel .
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select
a suitable programme for drain-
ing.
→ "Programmes", Page 29
Remove the laundry.
3.
→ "Unloading the laundry",
Page 39
13.11 Cancelling the drying
programme
Press Cancel .
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry for a
few minutes while the drum is ro-
tating. The door is then automatic-
ally unlocked.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wn54c8a10w

Table of Contents