Table of Contents
Advertisement
Colour
Grey
Changing a setting value
If a menu shows a scale for a setting,
you can change the setting value.
Requirement: The setting is activ-
ated.
→ "Activating or deactivating the set-
ting", Page 20
Press on the scale or wipe over
▶
the scale with your finger.
→ "Colours for settings", Page 20
The display shows the set value.
first time
6 Before using for the
first time
Prepare the appliance for use.
first time
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Press .
1.
Setting
Cannot be activ-
ated
The switch-on process takes a few
seconds.
a After a few seconds, the appliance
displays the start animation and
the programme overview.
Set the Drum Care programme.
2.
Close the door.
3.
Pull out the detergent drawer.
4.
Add washing powder to the
5.
manual dosing compartment.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
6.
Press
to start the programme.
7.
a The display shows the remaining
programme duration.
a After the programme has ended,
the display shows: "Finished" .
Start the first wash cycle or press
8.
to put the appliance in standby
mode.
→ "Basic operation", Page 36
first time en
21
Advertisement
Table of Contents
