Table of Contents
Advertisement
ATTENTION!
If residual water in the appliance
freezes, this may cause damage to
the appliance.
Do not install or operate this appli-
▶
ance anywhere that is liable to ex-
perience frost or outdoors.
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
Tilt the appliance carefully.
▶
Transport the appliance in an up-
▶
right position.
Installation loca-
tion
Base
Wooden joist
floor
Kitchen unit
Requirements
Secure the appli-
ance with fixing
brackets
→ Page 35.
Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
cent cabinets.
Required niche
width: 60.8 cm.
Installation and connection en
Installation loca-
tion
Against a wall
4.4 Removing foam parts
To prevent transport damage, the ap-
pliance is protected with foam parts
at the factory. Remove the foam
parts before switching on the appli-
ance.
WARNING
Risk of injury!
When the appliance is tilted, the ap-
pliance may tip over.
Tilt the appliance carefully.
▶
Do not tilt the appliance on your
▶
own.
ATTENTION!
If the foam material is not removed, it
can cause damage to the appliance
when it is operated.
Before starting up the appliance,
▶
remove all foam parts.
Tilt the appliance backwards.
1.
Requirements
Do not trap the
power cord or
the hoses
between the wall
and the appli-
ance.
13
Advertisement
Table of Contents
