Extron electronics USB HUB4 Series Setup Manual

USB HUB4 Series • Setup Guide
This guide provides basic instructions for setting up the
Extron USB HUB4 Series AAP and MAAP.
ACTIVITY
ACTIVITY
USB HUB4 MAAP
HUB4 USB MAAP
Installation
Step 1 — (Optional) Install the wall box or mounting bracket
If using an electrical wall box or a mounting bracket, install it in the wall or furniture (see
Mounting in the USB HUB4 Series User Guide available at www.extron.com).
Step 2 — Mount the HUB4 onto a mounting frame
Attach the USB HUB4 AAP or USB HUB4 MAAP to an appropriate AAP or MAAP sized
mounting frame, rack space frame, or other Extron architectural product (see Mounting in the
USB HUB4 Series User Guide).
Step 3 — Connect the USB HUB4 to the host computer
For ease of installation, connect the USB HUB4 to the host computer in either of the following
ways:
•
Using the Type mini-B USB port: Connect a Type A to
Type mini-B cable (provided) to the USB mini-B port on
the USB HUB4 rear panel.
•
Using the green captive screw USB In port: Remove
the Type B or Type mini B terminator from a Type A to B
or Type A to mini-B USB cable and insert the cable wires
into the 5-pole USB In port as shown below and at right.
This method may be necessary if space is limited.
(See Connecting to the captive screw USB port in the
USB HUB4 Series User Guide.)
NOTE:
computer. Do not connect the host computer to both HUB4 ports at the same time.
To Host
Computer
USB Port
Strip 1" to 2" from the outer jacket
of the USB cable to expose the wires.
Choose one of these two methods to connect the HUB4 to the host
Type mini B
Type A
USB Connector
USB
USB Cable (6')
ACTIVITY
ACTIVITY
HUB4 USB AAP
USB HUB4 AAP
USB HUB4 AAP
POWER
12V
1.1A MAX
Rear
Red / +V
White / D-
Green / D+
Black /
Braided Shield / S
Wire color
V+ (+5 VDC)
Red
White D- (Data -)
Green D+ (Data +)
–
Black
Braided shield S (Shield)
+ - + -
Captive
Screw
IN OUT
USB
USB IN
WIRE COLOR
Connector
R W G B
-
+V D- D+ S
Mounting
Frame
Port
(Ground)