Table of Contents
Advertisement
3.
Click
(see
figure
Next
files and places them in a folder identified in the InstallShield Wizard window.
ATTENTION:
•
The extension of the firmware file must be .s19. Opening a file with an incorrect
extension may cause the device to stop functioning.
•
L'extension du fichier firmware doit être .s19. Si un fichier est ouvert avec une
mauvaise extension, l'appareil peut arrêter de fonctionner.
NOTES:
•
Note the folder to which the firmware file is saved. When downloaded
from the Extron website, the firmware is placed in a subfolder of:
•
64-bit Windows OS:
•
32-bit Windows OS:
•
The original factory-installed firmware is permanently available on the unit. If
the attempted firmware upload fails, the unit reverts to the factory-installed
firmware.
4.
Click
to exit the program (
Finish
5.
Connect the computer to the rear panel Remote RS-232 port (see
or front panel Configuration (USB) port (see
6.
Start the Product Configuration Software and connect to the unit (see
Program, beginning on page 25).
7.
Click
>
Device Menu
Update firmware
want to continue the update (see figure 18 on the next page).
17,
on the previous page). The program extracts the firmware
3
\
C:
Program Files (x86)\Extron\Firmware
\
C:
Program Files\Extron\Firmware
).
4
item
A
. The software asks you to confirm that you
DTP T USW 333 • Remote Control
.
item
on page 7)
I
on page 12) of the switcher.
Starting the
.
28
Advertisement
Table of Contents
