Operation; Controls And Indications - Extron electronics DTP T USW 333 User Manual

Operation

Controls and Indications

AUTO
SWITCH
CONFIG
A A D D
Figure 9.
A
C
E
G
Auto Switch mode indicator
A
Input selection controls and indicators
B
C
Auto-input switching mode controls
The switcher supports auto-input switching mode. When auto-input switching mode is
enabled, the switcher continuously monitors all inputs and automatically switches to the
highest-numbered input with video sync pulses present. If video is absent from all inputs,
input 1 is selected.
D
E
F
C C
1 2
MODE NORMAL
E E
B B
DTP T USW 333 Front Panel Controls and Indicators
Auto Switch LED
Input 1 through 3 LEDs
Normal button
Status LEDs (see the next
Auto Switch LED — see
Input 1 through 3 buttons — Each Input button selects the associated input for
output (see Switching inputs
The Input buttons are also used to toggle auto-input switching mode on and off (see
"Auto-input switching mode controls").
Input 1 through 3 LEDs — The input LEDs identify the selected input.
Mode button — The
Mode
to select the switching mode (see
This button is a secondary function of the Input 1 button.
Normal button — The
Normal
mode (see Selecting the switch
This button is a secondary function of the Input 2 button.
When you change from auto-input switching to normal (manual) mode, the last input
selected in auto-input switching mode remains selected until you manually select a
different input.
Auto(switch) button — The
auto-input switching mode (see
This button is a secondary function of the Input 3 button.
3
SIGNAL
AUTO
F F
B
Input 1 through 3 buttons
D
Mode button
F
Auto(switch) button
page)
Selecting the switch mode
on page 14).
button is used with the
Normal
Selecting the switch
button is used with the
mode).
button is used with the
Auto
Selecting the switch
DTP T USW 333 • Installation and Operation
STATUS
1 2 3
HDCP
DTP T USW 333
G G
on page 15.
button or the button
Auto
mode).
button to select normal
Mode
button to select
Mode
mode).
13