Table of Contents
Advertisement
Figure 20.
Jumper Locations
4.
Reinstall the switcher cover, securing it in place with the screws removed in step 2.
5.
Reinstall the switcher in the rack or other installation option (see
Switcher
on page 31).
6.
If you are using shielded cable, disconnect the cable shield from the connector at
either end of the cable.
7.
See the manual for the applicable receiver available at www.extron.com, and remove
the ground jumpers in the receiver.
8.
Obtain a second 12 V power supply (one supply is provided with the switching
transmitter and normally powers both units), and locally power both units (see
supply wiring
on page 10).
ATTENTION:
•
This product is intended to be supplied by a UL Listed power source marked
"Class 2" or "LPS," rated 12 VDC, 1.0 A minimum. Always use a power supply
supplied by or specified by Extron. Use of an unauthorized power supply voids
all regulatory compliance certification and may cause damage to the supply
and the end product.
•
Ce produit est destiné à une utilisation avec une source d'alimentation listée UL
avec l'appellation « Classe 2 » ou « LPS » et normée 12 Vcc, 1,0 A minimum.
Utilisez toujours une source d'alimentation fournie ou recommandée par
Extron. L'utilisation d'une source d'alimentation non autorisée annule toute
conformité réglementaire et peut endommager la source d'alimentation ainsi
que le produit final.
Mounting the
DTP T USW 333 • Reference Information
JMP2
JMP1
Power
33
Advertisement
Table of Contents
