Replacing The Generator - Husqvarna 560XPG Workshop Manual

7.42 Replacing the generator

Dismantle the following parts:
• Clutch cover
• Bar and chain
• Cylinder cover
• Starter
• Flywheel *
* See the chapter "Dismantling the ignition module
and flywheel."
1. Loosen the screws to the generator without
removing it. See Figure 13.3
2. Loosen the return hose B and the tank bleeding
hose C. See Figure 16. Loosen the fuel tank's
rear mounting bracket, i.e. the rear vibration
element (D). Loosen the screw F as outlined in
Figure 14 a and remove the limiter cap band.
Lower the tank as much as possible to access
the attachment for the generator cable on the
tank. See Figure 14b.4
3. Loosen the generator cable from its cable lug
by the handle bar. Remove the generator and
cable and replace it with a new one.
4. Run the generator cable through the opening in
the crankcase, the attachment in the tank unit
and the front handle. Screw the generator in
place with a tightening torque of 5 Nm.
5. Lift the tank in place and attach it with the
screws D and F. Attach the return hose and the
tank bleeding hose. Connect the cabling in the
front handle and fit the following parts:
• Flywheel
• Cable bracket with cabling
• Power switch
• Cover
• Cylinder cover
• Tighten the screw for the earth cable.
• Bar and chain
• Clutch cover
Fig 13
D
Fig 14a
Fig 14b
Repair Instructions
F
English -
45