Replacing The Generator (Xpg) - Husqvarna 565 Workshop Manual

Ignition system

11.5 Replacing the generator (XPG)

1. The following components must be removed before
the generator can be replaced:
A. Starter. See figure 10.
B. Flywheel. See figure 10.
C. The rear vibration damping unit. See figure 10.
2. Unscrew the cover on the front handle. See figure
11.
3. Disconnect the three cables in the front handle.
See figure 12.
4. Remove the front handle (D) (five to six screws) and
the vibration damping unit connected to the front
hand grip. See figure 10 and 11.
5. Loosen the cable from the fastening on the tank. See
figure 13.
6. Dismantle the two screws (A) on the generator.
figure 14.
7. Lift out the generator and place the new generator.
See figure 15.
8. Push the cables between the tank unit and
carburettor area base and connect the cable to the
fastening on the tank. See figure 13.
9. Connect the three cables to the front handle. See
figure 12.
26 - English
Fig. 10
Fig. 11
See
Fig. 12
Fig. 13
Fig. 14
Fig. 15
D
B
C
A
A