1.
Dismantle the air filter, the filter holder, the
cable from the intake flange holder and the
carburettor and the throttle cable as outlined in
"Dismantling the carburettor".
NOTE!
The lug on the carburettor sits on the bracket
on the partition wall.
2.
Hook off the cabling H from the holder on the
intake system. Se figure 25a. Knock out the
POP-out window using a screwdriver. See
figure 25b. Lower the tank slightly and slide the
fuel hose down into the hole. Loosen the lower
screws of the intake system using the POP-out
hole and the fuel hose hole. Loosen the other
screws.
F
Fig 24
H
Fig 25a
Repair Instructions
G
27
English -