5. Dismantle the intake system. Pull up and then
outward. See figure 26.
7.19 Cleaning and inspection
•
Clean and check all parts carefully. Parts must
be replaced if cracked or showing signs of other
defects. Always use original spare parts.
7.18
Assembling the intake system
Assemble the intake system.
1.
Fit the lower screws of the intake system using
the POP-out hole and the fuel hose hole. Fit the
other screws. Fit the fuel hose and the throttle
cable to their attachments. See figure 24.
2.
Fit the rubber grommet to the throttle cable.
Push the tank back in position. Hook on the
cabling to the holder on the intake system.
3.
NOTE! Press the lug on the carburettor in place
on its bracket on the partition wall. See figure
24.
4.
Fit the carburettor, the filter holder and the air
filter as outlined in "Assembling the
carburettor".
28
- English
Fig 25b
Fig 26
H