Assembly Of Sealing Rings - Husqvarna 560XPG Workshop Manual

6. Assemble the following parts:
A. Tank unit.
B. Piston and cylinder.
C. Muffler.
D. Carburettor.
E. Centrifugal clutch.
F. Electrical System.
G. Starter.
H. Bar and chain. See the Operator's Manual.

7.50 Assembly of sealing rings

1. To replace the crankshaft's sealing rings, first
dismantle the following parts:
On the flywheel side:
• Starter.
• Flywheel.
On the clutch side:
• Bar and chain.
• Chain guide plate.
• Centrifugal clutch.
• Oil pump.
Use a screwdriver to remove the sealing ring
and pull it out.
NOTE! Excessively hard impact can move the
bearing.
2. Applyl 2-stroke oil on the sealing lip before
assembly.
3. Slide the dowel 575 34 69-01 (figure 80) on the
crankcase pin. Knock the new sealing ring in
place using the 575 34 70-01 tool. See Figure
81.
4. Fit the parts as outlined in point 1 above.
Fig 80
Fig 81
Repair Instructions
55
English -