Husqvarna 560XPG Workshop Manual page 47

5. Fit the new heating element and make sure that
no cables are pinched. See Figure 19.
6. Connect the cable to the carburettor's heating
element as outlined in Figure 18. Fit the filter
holder as outlined in Figure 17 and tighten
screws F. Attach the hoses as outlined in Figure
16.
7. Fit the new thermostat to the carburettor as
outlined in Figure 15 and connect the cabling.
Then fit the:
• Cable bracket with cabling
• Power switch
• Cover
• Air filter
• Cylinder cover
• Tighten the screw for the earth cable.
Fig 19
Repair Instructions
47
English -