Assembling The Throttle Control Lock, Throttle Control And Spring - Husqvarna 560XPG Workshop Manual

6.13 Assembling the throttle control
lock, throttle control and spring
1. Lubricate the pin and joined surfaces with a
light oil. Hook on the throttle cable (D). Slide in
the throttle control and make sure the spring is
fitted as outlined in figure 24.
NOTE! Make sure that the rear end of the
throttle control is correctly aligned inside the
cut-out edging before the pin is pressed in
place.2
2. Fit the throttle control's pin (C) using a punch.
See figure 25.
3. Fit the throttle control lock (B) by sliding it on
the shaft in the handle. See figure 26. Make
sure the spring is positioned inside the throttle
control lock when you press it down so that the
barbs are hooked in place.
4. Fit the handle insert using a screw, when the
throttle control, spring, throttle cable and
throttle control lock with pin are fitted correctly.
Fig 24
Fig 25
Fig 26
Safety equipment
C
18
English -