Replacing The Chain Catcher; Ismantling The Start/Stop Control - Husqvarna 555 Workshop Manual

Safety equipment

6.5 Replacing the chain catcher

A worn chain catcher must always be replaced with
a new one. Always use original spare parts.
1
Release the brake by mo ing the front hand guard
backward.
Loosen the bar nuts and remo e the clutch co er,
chain and bar.
2
ig 13
Remo e the chain catcher and replace it with a
new one.
Make sure that the ibration element is tted cor-
rectly on the crankcase when a new chain catcher
is screwed in place. See gure 13.
6.6 Dismantling the start/stop control
1
Remo e the cylinder co er and air lter. ismantle
the air lter holder. See the ismantling the carbu-
rettor chapter.
2
Loosen screw and dismantle the stop control A.
See gure 14. Unhook the rubber collar around the
control from the guide plugs.
Cleaning and inspection
Clean and check carefully all components. Parts
ig 14
must be replaced if cracked or show signs of other
defects. Always use original spare parts.
20
- English