Vibration Damping System; Generator - Husqvarna 555 Workshop Manual

7.16 Vibration damping system

7.16.1 To disassemble and assemble the vibration
damping system
1. Use a Torx to remove the vibration damping unit
from the cylinder.
2. Remove the chain catcher to get access to the
vibration damping unit.
3. Remove the screw to get access to the vibration
damping unit. Use a Torx to remove the vibration
damping unit.
4. Assemble in the opposite sequence.
1540 - 001 -

7.17 Generator

7.17.1 To remove the generator
1. Remove the fuel tank. Refer to
install the fuel tank on page 41 .
2. Remove the starter unit. Refer to
the starter unit on page 25 .
3. Remove the flywheel. Refer to
flywheel on page 30 .
4. Remove the 2 screws.
5. Remove the generator and the wires.
7.17.2 To install the generator
1. Pull the cables through the hole in the crankcase.
2. Attach the generator to the crankcase. Tighten the
screws to the correct torque. Refer to
on page 7 .
3. Install the flywheel.
4. Install the starter unit.
To remove and
To disassemble
To remove the
Servicing data
Repair instructions - 45