Flush Mounting A Series Side By Side - Furuno MU-152HD Operator's Manual

1. MOUNTING, WIRING
4. Connect all cables at the back of the display unit. See section 1.7.
5. Loosen the knobs of the bracket support and set them in the notches on the hanger 15 as-
sembly.
Hanger 15 Assembly
6. Adjust the angle of the display unit and fix the knobs tightly.
1.6

Flush Mounting a Series Side by Side

You can flush mount two display units side by side.
1. Make a cutout in the mounting location as shown below.
2. Follow step 2 to step 5 in section 1.2 to set the two display units in the mounting location.
Note: Attach the attachment 15 to the top, bottom, left, and right as shown in the figure below.
736±1 (28.98")
4-ø18(0.71")*
*: The drill bit with a diameter of 18 mm or
less can also be used.
15
Knob
Attachment15