Furuno MU-152HD Operator's Manual page 17

2. Attach the flush mounting sponges H15 and V15 in the order shown in the figure below.
3. Attach the flush mounting panel (15) to the display unit from the rear with the washer head
screws (M410, 8 places, torque: 1.2 N•m). Do not confuse the top and bottom of the panel
and check that screw holes on the panel and unit match.
Narrow
4. Connect all cables at the back of the display unit. See section 1.7.
5. Set the display unit assembly prepared at the section 3 to the cutout for the mounting location.
Fmount sponge V15
for right and left
Wide
Fmount sponge H15 for
top and bottom
Washer
Head
Screw
Fmount panel 15
assembly
8
1. MOUNTING, WIRING