Removing The Seat - KTM 250 SX-F 2021 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.24
66
S01229-10
F01581-11

Removing the seat

Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever on
angle lever
Info
Pay attention to flat area
–
Mount and tighten screw
Guideline
Screw, bottom M10
shock absorber
Info
Raise the swingarm slightly to be able to mount the
screw more easily.
–
Position the left frame protector.
–
Insert the right frame protector from below and push it to the
rear.
–
Mount and tighten screws
Guideline
Screw, frame protec-
tor
–
Mount and tighten screw
Guideline
Screw, frame protec-
tor
–
Mount the new cable ties.
Finishing work
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
6
.
M14x1.5 60 Nm (44.3 lbf ft)
B
.
7
.
60 Nm (44.3 lbf ft)
Loctite ®
8
with the washers.
M5 3 Nm (2.2 lbf ft)
9
.
M5 3 Nm (2.2 lbf ft)
p. 94)
p. 50)
2701™