23 Declarations Of Conformity - KTM 250 SX-F 2021 Owner's Manual

23 DECLARATIONS OF CONFORMITY

23.1
KTM AG hereby declares that the Connectivity Control Unit wireless system conforms with the relevant guidelines.
The full text of the Declaration of Conformity is available at the following Internet address.
Certification website: http://www.ktm.com/ccu-2
23.2
Connectivity Control Unit
FCC ID: 2A0W7-K001
IC: 5966A-K001
Declaration regarding modifications
Alterations and modifications not expressly approved by the relevant authority may result in the user being prohib-
ited from operating the equipment.
Declaration regarding interference
This device fulfills Part 15 of the FCC regulations as well as the license-free RSS standards of the Canadian Gov-
ernment Department Industry Canada.
Operation is subject to the following two conditions:
1 This device must not cause interference.
2 This device must be able to absorb any interference, including interference that potentially causes undesir-
able operation of the device.
Note on radio transmissions
This device corresponds to the FCC limit values for radiation exposure, which have been determined for a non-
controlled environment, and fulfills the FCC guidelines for the load from radio frequencies.
The transmitter must not be set up near to other antennas or transmitters or operated in conjunction with other
antennas or transmitters.
Note on digital devices of Class B according to the FCC regulations
This device has been tested and fulfills the limit values for digital devices of Class B according to the FCC regula-
tions, Part 15.
These limit values are designed so as to provide sufficient protection from harmful interference in residential
areas.
Devices of this type generate and use high frequencies and can also emit these. Therefore, if they are not
installed and operated in accordance with the instructions, they may cause harmful interference to radio
reception. However, there is no guarantee that interference will not occur in certain cases of application.
Should this device cause harmful interference to radio or television reception, (check this by switching the device
on and off), you can potentially eliminate this interference as follows:
–
Re-align the receiving antenna.
–
Increase the separation between device and radio receiver.
–
Connect the device and the radio receiver to separate electric circuits.
–
Consult your dealer or a radio/TV technician.
CAN ICES‑3 (B) / NMB‑3 (B)
This digital device of Class B fulfills the regulations in accordance with the Canadian Interference-Causing Equip-
ment Standard ICES‑003 / NMB‑003.
146
Declarations of conformity
Info
The functional and equipment scope is model-dependent and may not include all wireless systems and
application areas referred to.
Declarations of conformity
Info
The functional and equipment scope is model-dependent and may not include all wireless systems and
application areas referred to.