General Information; Introduction; Key Features; Specifications - Delta A6000 User Manual

USER MANUAL
A6000
AC POWER SOURCE

1. General Information

1.1 Introduction

This manual describes the specifications, installation and operation instructions of
Delta DME-A602ABS SERIES Programmable AC Power Source. In this manual the term,
AC Source, stands for Delta DME-A602ABS SERIES Programmable AC Source.
The series of AC source is a high efficiency programmable ac power source, which
provide low distortion sinusoid AC voltage output and measurement. Stable voltage and
frequency are obtained through accurate digital calculation provided by DSP IC. Remote
programming is accomplished either by the GPIB bus or by the RS-232C serial port.

1.2 Key Features

I. Configuration
• Local operation from the front panel keypad
• Protection against Over-power, Over-load, Over-temperature, and Fan-fail
• Fan speed controlled by output power
• Built-in isolation output relays
• Remote operation via GPIB or RS-232C interface
II. Input/output
• Selective output voltage ranges with full scale of 150V/32A and 300V/16A
• V, I, F, P, CF, PF, Ip, Is, VA, and VAR measurements
• Remote inhibited control
• AC ON/OFF, FAULT OUT TTL output signal.

1.3 Specifications

The operation specifications of DME-A602ABS SERIES Programmable AC Power
Source are listed below. All specifications have been tested according to the standard
of Delta test procedures. All specifications are based on resistor load with remote sense
connection, under 25±1ºC unless specified otherwise.
Model
Output Phase
Output Power
Power/phase
Voltage
Range/Phase
Accuracy
6 │ www.deltaww.com
DME-A602ABS SERIES
1 (parallel or series)
6000 VA
150V / 300V (parallel)
300V / 600V (series)
0.2%+0.2%F.S. (parallel)
0.4%+0.4%F.S. (series)