Table of Contents
Advertisement
USER MANUAL
A6000
AC POWER SOURCE
3. Local Operation
3.1 Introduction
The AC source can be configured to operate in local or remote mode. The operation
in remote mode through GPIB controller or RS-232C will be described in Chapter 6. This
chapter describes the operation in local mode through the keypad on the front panel for
data entry and test. If remote control cable are not connected, the AC source is configured
for local operation after AC switch is on.
LCD panel will show the self-test message as below after AC switch is on.
Then will enter main manual setting page as below. Default SET MODE is "Parallel"
means parallel output operation. Operator can set output voltage and frequency.
17
│ www.deltaww.com
Advertisement
Table of Contents
